Sampletekk - Renaissance Flutes (Kontakt, NKI EXS FXP) torrent

Программы и Дизайн » Материалы для мультимедиа и дизайна » Библиотеки и саундбанки для сэмплеров, пресеты для синтезаторов

Renaissance Flutes

Производитель: Sampletekk
Сайт: _http://www.sampletekk.com/proddetail.php?prod=STDELIVER-009-FORMAT
Формат: NKI EXS FXP
Качество: 24 bit Частота 44.1 kHz Каналы stereo
Описание: 5 блок-флейт различных регистров (от баса до сопранино) для озвучивания ранней музыки. В каждой по 5 артикуляций - вибрато и нон вибрато, портато вибрато и портато нон вибрато, и стаккато Успехов в игре и творчестве!)
[spoiler="Содержание"]
Alto Recorder
Range F3 – G#5

Bass Recorder
Range F2 – F4

Sopranino Recorder
Range F4 – F6

Soprano Recorder
Range C4 – D#6

Tenor Recorder
Range C3 – D#5
[/spoiler]
[spoiler="Дополнительная информация"]
A complete set of recorders, Bass, Alto, Tenor, Soprano and Sopranino,beautifully played by one of Sweden's top flutists and recorded at Fascination Street Studios in Orebro, Sweden.

This set of recorders gives you the possibility to perform classic recorder music, to explore the wonderful tone of the recorders or use as a great mood setter in your music, (remember "Stairway to heaven"?) The recorders have been recorded (!) chromatically, that is, all notes within the instruments natural range has been recorded. There are no loops! Each tone is held for about 5 seconds, and that's how long a musician normally can hold a note without breathing.

As you can see, all flutes has relatively short range, but this is the way recorders play, and rather then stretching it artificially, we kept it the way it is.
Each flute also has its own timbre, so when you choose flute, you should listen to it’s sound and not only go after its range.
All flutes has only one velocity layer. Now, for an instrument coming from SampleTekk, that might seem a bit strange.
The fact is that recorders are not an instrument that are depending that much on different velocities. They are not meant to have different timbre when playing hard or soft.

The flutes have a difference in amplitude from the low end to the high end of the range.
The low notes are played softer and the high range louder. This is from the playing technique.
You have to blow harder to hit the higher notes and softer to get the lower ones.
These differences have been kept in the sampled instrument for realism.
The Patches Each flute comes with 5 different patches. The Vibrato and Non Vibrato patches have release samples that will trigger when you release the key. This gives you a very natural feel, even when playing fast runs!

1. Vibrato – This is a parch where the recorders are played with a vibrato that kicks in after about Ѕ of a second
2. Non Vibrato – Notes played without vibrato
3. Portato Vibrato– Ok, this one needs a bit of explanation! This is when you play a note and then go to another note by covering another hole on the flute. The new note then starts without any new attack. When, for instance, the note D where recorded for the portato patches, the flutist played the note C, and then went to D just by covering a new hole on the flute with his finger. The samples where then edited so that it starts exactly when D starts. If you use these patches, you can emulate runs and thrills. This patch has vibrato in it in the same way as the Vibrato patch has.
4. Portato Non Vibrato – You guessed it!
5. Staccato – Staccato notes, you can try this on faster runs, but the release samples in the
Vibrato and Non Vibrato patches does a pretty good job on faster runs!
[/spoiler]